saw guide 4

After you have finished fastening the components together and all of the fasteners are set or flush and the glue is dried there is only one more thing to do and your done!

All you have to do now is to take your circular saw and set the depth of cut a little deeper than the thickness of the sawboard base.

Position your saw so that the motor side of its table (or foot) is against the edge of the guide ripper and the saw foot itself is resting on the open side of the saw board base.

Then slowly and carefully make your cut making sure that you stay tight against the edge of the guide ripper until the excess material of the sawguide base is cut off.

That's it!
That's all there is to it!
You now have your very own customized sawguide straight cut system that will serve you well for many years to come.