saw guide part 3

All you have to do is attach the guide ripper to the sawboard base at one long edge flush to three sides.
You can use whatever fastening system that suits your fancy but I recommend using yellow carpenters glue and clamping until dry.

If you glue, keep an eye on the edge alignment as you clamp, sometimes clamps will push pieces out of alignment as you tighten them down.

Also have a damp rag handy to catch those gushes and oozes (this could be real important for the accuracy of the saw guide).

If you decide to nail or screw, either one will work just fine, but just be careful to set and countersink everything and be sure that there are no points poking through otherwise it will defeat one of the great features of the sawguide we will discuss later.